This heat recovery is able to reduce decisively the amount of required primary energy. Here for example a highly efficient, fully welded plate heat exchanger type FunkeBloc with high surface density can be applied. The pre-heated charged glycol is now fed into a stripper column (4) in which humidity and fou-ling substances are removed from the glycol again. After this, the cleaned glycol flows through a
Block-type & Fully-welded Plate Heat Exchanger is a new product in the compact heat exchanger family. The plate bundle fully welded with plate sheets is mounted into a frame of 4 bolted side panels with a top plate and a base plate sustaining pressure. The side panels are provided with nozzles with fluid inlet and outlet. Fully Welded Plate Heat Exchangers K°Bloc KelvionThe KºBloc is a fully-welded plate heat exchanger that is used above all in the oil and gas industry, the chemical industry as well as in the petrochemical sector. The solidly bolted frame consists of four columns, top and bottom heads as well as four side panels. These side panels can be detached swiftly and allow free access all the way around for the thorough and easy cleaning of the fully-welded plate package.
SmartBLOCK is a welded plate type heat exchanger that can be opened at both sides and designed without any seal gaskets installed between heat transfer plates, it can provide large heat transfer area within a compact space, and can be opened at two sides for cleaning. Products KelvionK°Bloc for oil and gas as well as petrochemicals. fully welded plate pack. small footprint and low installation cost. access to both media sides. for applications at temperatures up to 400°C and pressures up to 50 bar. easy cleaning thanks to unproblematic opening of the apparatus. Show more. K°Flex A new dimension of efficiency and flexibility.
Your email address will not be published.*